- This topic has 1 reply, 2 voices, and was last updated 9 months, 1 week ago by
.
-
Posts
-
I recently installed a System Sensor RTS151KEY remote test and reset station in my fire alarm system, but I’m experiencing some issues. The LED indicators seem to be behaving unexpectedly, and I’m not sure how to diagnose the problem. Can anyone offer some troubleshooting tips?
Sure, I’d be happy to help troubleshoot the issue with your System Sensor RTS151KEY. Firstly, ensure that the device is properly wired and connected to the fire alarm control panel. Check for any loose connections or damaged wiring.
Next, let’s focus on the LED indicators. The LED lights on the RTS151KEY provide important diagnostic information. If the LEDs are not behaving as expected, it could indicate a fault or error condition.
Refer to the installation manual for the RTS151KEY to understand the meaning of different LED patterns. For example, a steady green LED typically indicates normal operation, while a flashing red LED might indicate a fault or alarm condition.
If the LEDs are not displaying the expected patterns, try power cycling the device by disconnecting and reconnecting the power supply. Sometimes, a simple reset can resolve minor issues.
If the problem persists after power cycling, consider checking the compatibility of the RTS151KEY with your fire alarm control panel. Ensure that it is compatible with the panel’s protocol and communication requirements.
If you’re still unable to resolve the issue, I recommend reaching out to System Sensor technical support for further assistance. They can provide expert guidance and troubleshooting steps specific to the RTS151KEY model.
By following these steps, you should be able to diagnose and address the issues you’re experiencing with the System Sensor RTS151KEY remote test and reset station.
- You must be logged in to reply to this topic.