Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #5621
    Natalie Hall
    Participant

    Hey I’m installing a System Sensor 4WTAR-B in my building, but I’m a bit confused about the wiring. Can someone provide guidance on how to properly wire this device?

    • This topic was modified 8 months, 1 week ago by Khris James.
    #5622
    Khris James
    Moderator

    Absolutely, Natalie! Sure! The System Sensor 4WTAR-B is a 4-wire photo, thermal, and sound detector designed for fire alarm systems. To properly wire it, you’ll need to connect the device to the appropriate terminals on your control panel. The red and black wires are for power (+24VDC) and ground, while the yellow and blue wires are for the signal and sounder circuit. Make sure to follow the manufacturer’s instructions and consult your local fire code regulations to ensure compliance with wiring standards.

    • This reply was modified 8 months, 1 week ago by Khris James.
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.
Scroll to Top