- This topic has 1 reply, 2 voices, and was last updated 8 months, 3 weeks ago by
.
-
Posts
-
I recently installed an Edwards Signaling FSP502G in my building, but I’m having trouble integrating it into my fire alarm system. Can someone guide me on how to properly set it up? This falls under the ‘System Guide’ category.
Sure! Integrating the Edwards Signaling FSP502G into your fire alarm system involves a few key steps. First, ensure that the wiring is correctly connected to the control panel. The FSP502G typically requires a separate power source and relay for activation.
Next, program the control panel to recognize the FSP502G as a notification device. This usually involves assigning a zone or circuit to the device and configuring its activation parameters, such as alarm type and synchronization.
Finally, conduct thorough testing to ensure the FSP502G activates as intended during fire alarm events. If you encounter any issues during setup, consult the device’s installation manual or reach out to Edwards Signaling technical support for assistance.
- You must be logged in to reply to this topic.