- This topic has 1 reply, 2 voices, and was last updated 9 months ago by
.
-
Posts
-
Hi everyone, I’m encountering some issues with my Siemens XTRI-S fire alarm system. The trouble light is on, and I’m not sure what the problem could be. Any ideas on how to troubleshoot this?
Hey there! When the trouble light is on with the Siemens XTRI-S, it typically indicates a fault in the system. Here are a few steps you can take to troubleshoot:
Check Display: First, check the display panel for any specific error codes or messages. This can give you a clue about what’s going on.
Inspect Devices: Make sure all devices connected to the system, such as smoke detectors, pull stations, and annunciators, are properly functioning and not indicating any faults themselves.
Power Cycle: Sometimes, a simple power cycle can resolve temporary issues. Try turning off the power to the system for a few minutes, then turn it back on and see if the trouble light clears.
Review Documentation: Refer to the system manual or documentation for troubleshooting guidance specific to the Siemens XTRI-S. It may provide detailed steps for common issues.
If after trying these steps the trouble light persists, it might be best to contact a certified technician for further assistance, as there could be a more complex issue at hand. Let me know if you have any other questions!
- You must be logged in to reply to this topic.